WATER HEATED CENTRIFUGES

The Robinson WATER HEATED unit operates on vehicle engine heat absorbed into the cooling system.
By simply circulating the vehicle's cooling media through the centrifuge's watertight cavity, media heat is absorbed by the aluminum housing. Depending on the engine thermostat, centrifuge location, and water hose insulation going on the centrifuge, the unit will produce a temperature of approximately 150 degrees F.

Centrifuge features include:
1. A circular design offering a high-efficiency unit that meets or exceeds the RCF requirements of API and ASTM.
2. A heavy aluminum casting with a large watertight cavity for maximum heating capacity. The larger the cavity, the more hot water circulating in the centrifuge, the greater the BTU's available for heating the oil sample.
3. A rheostat control with an "off" position for a slow, smooth start and speed control.
4. Top-entry motor removal for replacement without having to remove the centrifuge from its mountings.
5. A motor mount plate with a ball bearing provides stabilizing support for the motor shaft.
6. One-inch thick mounting feet to reduce casting failures.
7. Lid designed with a hole in the center so that the centrifuge RPM's can be checked with a hand held tachometer with the centrifuge lid closed.
8. A pre-heater section, with four pockets, located in front of the centrifuge for easy operator access.

Specifications: 100ml short cone, 12 VDC, water heated, 23 ½" x 20" x 10 ½", 54 lbs.

2000 Bill Poole Products